What's in the Box
Square array microphone with loudspeaker
Hardware kit with:
Cable ties (8)
Strain relief tabs (3)
Rubber pad set
Reset Button
The reset button is behind the grille with a silkscreened circle around it. To push it, use a paper clip or other tool. You can also
reset the device using the control software.
Reset Modes
•
Network reset (press for 4-8 seconds): Resets all Shure control and audio network IP settings to factory defaults. Red
LED along bar.
•
Full factory reset (press for more than 8 seconds): Resets all network and configuration settings to the factory defaults.
Multicolor flash, then blue LED along bar.
MXA902 Control Software
There are 2 ways to control the MXA902:
•
Use Shure Designer software (download at shure.com/designer)
◦
Control all Shure devices in one place.
◦
Route audio to and from Shure devices.
•
Open the MXA902's web application with
◦
Control 1 device at a time.
◦
Route audio with
Dante Controller
MXA902-S or MXA902-S-60CM
90A49117
Shure Web Device Discovery
software.
(download at shure.com)
Shure Incorporated
10/38