IBM TotalStorage DS300 Hardware Installation And User's Manual page 95

10. Remove the 7-disk drive cover from the bezel and install the bezel (see
"Installing and removing the bezel on DS300 (models 1701-1RS and
1701-2RD) and DS400 storage subsystems" on page 58).
11. Connect the power cord to the power supply.
12. Untwist the power cord strain-relief plastic tie (located below and to the right of
the ac power switch).
13. Wrap the strain-relief tie around the power cord approximately 10 cm (4 in.)
from the ac power connector end; then, twist the tie.
14. Connect the power-supply cord into a properly grounded electrical outlet.
Note: The fault (amber) LED is lit on the new power supply because its power
switch is turned off.
15. Turn on the power supply.
After you turn on the power, the fault (amber) LED is off and the power OK
(green) LEDs are lit. For more information about the power-supply LEDs and
controls, see "Power supply controls and LEDs" on page 20 and "Power supply
controls and LEDs" on page 46.
Chapter 10. Installing and replacing components
79