Monitoring Status Through Software - IBM TotalStorage DS300 Hardware Installation And User's Manual

4. Complete step 2 on page 51 to determine the correct power-on sequence for
5. When the internal temperature of the storage subsystem is below 45°C (113°F),

Monitoring status through software

Use the ServeRAID Manager program to monitor the status of the storage
subsystem. Run the program constantly, and check it frequently.
The ServeRAID Manager program provides the best way to diagnose and repair
storage-subsystem failures. The program can help you:
v Determine the nature of the failure
v Locate the failed component
v Determine the recovery procedures to repair the failure
Although the storage subsystem has fault LEDs, the LEDs do not necessarily
indicate which component has failed or must be replaced, or which type of recovery
procedure that you must perform. In some cases (such as loss of redundancy in
various components), the fault LED is not lit. Only the ServeRAID Manager program
can detect the failure.
the system.
complete steps 3 on page 51 and 4 on page 52 to turn on power to the devices
in the system and to check the status of the storage subsystem.
Chapter 9. Turning the storage subsystem on and off
55