Installing/Removing The Server In/From The Rack - Fujitsu PRIMERGY RX100 S4 Server Operating Manual

Hardware installation
4.3 Installing/removing the server in/from the
rack
V
CAUTION!
Follow the safety instructions in chapter
page 19
The rack can tip over when more than one unit is removed.
V
CAUTION!
The server does not have cable management in the rack.
Before removal, all cables connected to the server must be removed
from the sockets. Proceed as follows:
Exit all applications and shut down the operating system properly.
Switch off the server.
Disconnect and remove all cables connected to the server.
Remove the server.
RX100 S4

Installing/removing the server in/from the rack

and section "Rack installation instructions" on page
Operating manual
"Important information" on
30.
35