7
Troubleshooting and tips
V
CAUTION!
Follow the safety instructions in the "Safety notes and other important
information" manual and in chapter
If a fault occurs, attempt to resolve it using the measures described:
– in this chapter,
– in the documentation for the connected devices,
– in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Make a list of the steps performed and the circumstances that led to the fault.
Also make a list of any error messages that were displayed.
Ê Switch off the server.
Ê Contact our customer service team (see "Warranty" under
page
77).
7.1
Power on indicator remains unlit
The power on indicator remains unlit after switching on:
Power cable incorrectly connected
Ê Make sure that the power cable is correctly connected to the server and to
the grounded socket.
Power supply overloaded
Ê Disconnect the server power plug from the insulated socket.
Ê Wait a few seconds before you plug it into the insulated socket again.
Ê Switch on your server.
RX100 S4
"Hardware installation" on page
Operating manual
33.
"Literature" on
65