Mvme712M Transition Module Installation - Motorola MVME1603 Installation And Use Manual

MVME712M Transition Module Installation

1
MVME712M Transition Module Installation
!
Caution
!
Warning
!
Caution
1-42
The MVME712M transition module is used in conjunction with the
MVME1600-011 base board. With the MVME1603/1604 installed, refer
to Figure 1-13 and proceed as follows to install an MVME712M transition
module:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VMEmodules.
Inserting or removing modules with power applied may result
in damage to module components.
Dangerous voltages, capable of causing death, are present in
this equipment. Use extreme caution when handling, testing,
and adjusting.
3. Remove the filler panel(s) from the appropriate card slot(s) at the
front or rear of the chassis. (You may need to shift other modules in
the chassis to allow space for the MVME712M, which has a double-
wide front panel.)
4. Attach the P2 adapter board and cable(s) to the P2 backplane
connector at the slot occupied by the MVME1600-011 base board.
5. Route the 64-conductor cable to P2 on the transition module. Be
sure to orient cable pin 1 with connector pin 1.
Avoid touching areas of integrated circuitry; static discharge
can damage these circuits