Installing The Rtm; Cpip5430-Rtm Transition Module Installation - Motorola CPIP5430 Installation And Use Manual

Single board computer and transition module

Table of Contents

Reference Designator

J10

J11

J12

J13

J14

J15

J16

Installing the RTM

Before installing the CPIP5430-RTM1, you should install the

CompactFlash memory card.

Use the following steps to install the CPIP5430-RTM1 into your computer

chassis.

1. Attach an ESD strap to your wrist. Attach the other end of the ESD

strap to the chassis as a ground. Keep the ESD secured throughout this

procedure.

2. Shut down the operating system.

3. Turn AC or DC power off and remove the AC cord or DC power lines

from the system, or power down or remove the CPIP5430.

4. Remove the chassis or system cover(s) as necessary for access to the

chassis backplane.

5. Locate the desired peripheral slot.

6. Remove any filler panel (or existing board) that might fill that slot.

http://www.motorola.com/computer/literature

Table 5-2. Connector Reference (continued)

Connector Function

PMC (power)

Serial ATA (signal)

CompactFlash

IDE Hard Drive Header

PMC (signal)

VPD Write

IDE master/slave

Installing the RTM

5-7

Table of Contents