Single board computer and transition module (87 pages)
Summary of Contents for Motorola MVME197DP
Page 1
MVME197IG/D1A1 May 1994 Supplement to MVME197DP and MVME197SP Single Board Computers Installation Guide (MVME197IG/D1) The attached pages are replacements and/or additions to the installation guide. They correct minor errors and update some features. Please replace the pages according to the following table and place this page behind...
Motorola, Inc. assumes no liability resulting from any omissions in this document, or from the use of the information obtained therein. Motorola reserves the right to revise this document and to make changes from time to time in the content hereof without obligation of Motorola to notify any person of such revision or changes.
Related Documentation The following publications are applicable to the MVME197 module series and may provide additional helpful information. If not shipped with this product, they may be purchased by contacting your Motorola sales office. Motorola Document Title Publication Number MVME197LE Single Board Computer User’s Manual...
Page 4
Intel i82596 Ethernet Controller User’s Manual Cirrus Logic CD2401 Serial Controller User’s Manual SGS-Thompson MK48T08 NVRAM/TOD Clock Data Sheet The following non-Motorola publications may also be of interest and may be obtained from the sources indicated. The VMEbus Specification is contained in ANSI/IEEE Standard 1014-1987.
BOARD LEVEL HARDWARE DESCRIPTION Introduction This chapter describes the board level hardware features of the MVME197DP and MVME197SP versions of the MVME197 series of Single Board Computers, hereafter referred to as the MVME197, unless separately specified (refer to the next section for model designations).
Page 6
Each MVME197 module is a double-high VMEmodule based on the MC88110 RISC (Reduced Instruction Set Computing) microprocessor. The MVME197DP/SP module series have 128/256MB of onboard DRAM with programmable ECC (Error Checking and Correction), 256KB of external cache memory for each MC88110/MC88410 microprocessor/cache controller...
Page 7
VMEbus Specification (IEEE 1014-87) EIA-232-D Serial Interface Specification, EIA SCSI Specification, ANSI Features These are some of the major features of the MVME197DP/SP single board computers: Single MC88110 RISC Microprocessor with an MC88410 Cache Controller (MVME197SP module series) Dual MC88110 RISC Microprocessors, each with one MC88410 Cache...
BLT (D16/D32/D64)) – VMEbus interrupter – VMEbus interrupt handler – Global CSR for inter-processor communications – DMA for fast local memory - VMEbus transfers (A16/A24/A32, D16/D32 BLT (D16/D32/D64)) Specifications The specifications for the MVME197DP/SP are listed in the following table. MVME197IG/D1A1...
Page 9
ECDM (X4) Data Bus Mezzanine C EEPROM BusSwitch C Bus Port Addr Data LOCAL PERIPHERAL Address Bus NVRAM/RTC Data Bus BOOT ROM VMEbus SCSI -II Flash 4 Serial Ports PCCchip2 (VMEchip2) 82596CA Memory NCR53710 CL-CD2401 Figure 1-2. MVME197DP Block Diagram...
It is normally used to abort program execution and return to the debugger. This capability is controlled via the ABORT register in the BusSwitch. Refer to the BusSwitch chapter of the MVME197LE, MVME197DP, and MVME197SP Single Board Computers Programmer’s Reference Guide for more information.
MC88110 Second Generation RISC Microprocessor User’s Manual for more detailed information on this device. MC88410 Cache Controller Depending on the specific MVME197DP/SP module version, each MC88110 microprocessor is connected directly to an MC88410 Secondary Cache Controller. Each MC88410 controls a 256KB level two cache. Refer to the MC88410 Secondary Cache Controller User’s Manual and the MCM62110 Data...
It is not accessible from the local peripheral bus or VMEbus. Onboard DRAM The onboard DRAM on the MVME197DP/SP (2 banks of 128MB memory, one optionally installed) is sized at 128MB using 4M x 4 devices and configured as 256 bits wide.