Installing Transition Modules And Adapter Boards; Connecting Peripherals; Transition Module And Adapter Board Installation Overview - Motorola MVME187 Installation Manual

Hardware Preparation and Installation

Installing Transition Modules and Adapter Boards

Table 3-11. Transition Module and Adapter Board Installation Overview
3
Stage
1 Set jumpers on the transition
module(s) and install SCSI
terminators (if needed) on the P2
adapter board.
2 Connect and install the MVME712X
transition module
rear of the chassis
Connect and install
3

Connecting Peripherals

3-20
What you will need to do...
in the front or the
.
The P2 adapter board at the
P2 connector on the
backplane at the MVME187
slot.
SCSI cable(s) from the P2
adapter board to the
MVME712X transition
module and internal SCSI
devices.
The MVME187 mates with (optional) terminals or other peripherals
at the EIA-232-D serial ports (marked SERIAL PORTS 1, 2, 3, and 4
on the MVME712X transition module), parallel port, SCSI ports,
and LAN Ethernet port, as shown in
Some cable(s) are not provided with the MVME712X
Note
module(s), and therefore are made or provided by the
user. (Motorola recommends using shielded cables for
all connections to peripherals to minimize radiation.)
Refer to...
Module Preparation in the userÕs
manual for your transition module
and adapter board, and
SCSI Bus Termination on page 3-29
Installation Instructions in the userÕs
manual for your transition module
and adapter board
Installation Instructions in the userÕs
manual for your transition module
and adapter board
Module Preparation in the userÕs
manual for your transition module
and adapter board, and SCSI Bus
Termination on page 3-29
Figure 3-3 on page 3-22.