Mvme760 Transition Module Installation - Motorola MVME1603 Installation And Use Manual

4. Slide the MVME1603/1604 into the selected card slot. Be sure the
Avoid touching areas of integrated circuitry; static discharge
!
can damage these circuits
Caution
5. Secure the MVME1603/1604 in the chassis with the screws
6. On the chassis backplane, remove the
Note
7. Replace the chassis or system cover(s), cable peripherals to the

MVME760 Transition Module Installation

The MVME760 transition module is used in conjunction with the
MVME1600-001 base board. With the MVME1603/1604 installed, refer
to Figure 1-12 and proceed as follows to install an MVME760 transition
module:
– If you do not intend to use the MVME1603/1604 as system
controller, it can occupy any unused double-height card slot.
module is seated properly in the P1 and P2 connectors on the
backplane. Do not damage or bend connector pins.
provided, making good contact with the transverse mounting rails to
minimize RF emissions.
(IACK) and
BUS GRANT
slot occupied by the MVME1603/1604.
Some VME backplanes (e.g., those used in Motorola
''Modular Chassis'' systems) have an autojumpering feature
for automatic propagation of the IACK and BG signals. Step
6 does not apply to such backplane designs.
panel connectors as appropriate, reconnect the system to the AC or
DC power source, and turn the equipment power on.
Hardware Preparation and Installation
INTERRUPT ACKNOWLEDGE
(BG) jumpers from the header for the card
1
1-39