Mvme1603/1604 Vmemodule Installation - Motorola MVME1603 Installation And Use Manual

MVME1603/1604 VMEmodule Installation

1
MVME1603/1604 VMEmodule Installation
!
Caution
!
Warning
1-38
Install two similar screws in the bottom (tabbed) corners of the
RAM104. Tighten the screws.
11. Reinstall the MVME1603/1604 assembly in its proper card slot. Be
sure the module is seated properly in the backplane connectors. Do
not damage or bend connector pins.
12. Replace the chassis or system cover(s), reconnect the system to the
AC or DC power source, and turn the equipment power on.
With mezzanine boards installed and headers properly configured, proceed
as follows to install the MVME1603/1604 in the VME chassis:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VMEmodules.
Inserting or removing modules with power applied may result
in damage to module components.
Dangerous voltages, capable of causing death, are present in
this equipment. Use extreme caution when handling, testing,
and adjusting.
3. Remove the filler panel from the card slot where you are going to
install the MVME1603/1604.
– If you intend to use the MVME1603/1604 as system controller,
it must occupy the leftmost card slot (slot 1). The system
controller must be in slot 1 to correctly initiate the bus-grant
daisy-chain and to ensure proper operation of the IACK daisy-
chain driver.