Vmebus System Controller Selection (J10) - Motorola MVME1603 Installation And Use Manual

MVME1600-011 Base Board Preparation
1

VMEbus System Controller Selection (J10)

1-22
The MVME1600-011 is factory-configured in system controller mode
(i.e., a jumper is installed across pins 2 and 3 of header J10). This means
that the MVME1600-011 assumes the role of system controller at system
power-up or reset.
Leave the jumper installed across pins 2 and 3 if you intend to operate the
MVME1600-011 as system controller in all cases.
Remove the jumper from J10 if the MVME1600-011 is not to operate as
system controller under any circumstances.
Note that when the MVME1600-011 is functioning as system controller,
the LED is turned on.
SYS
J10
3
2
1
System Controller
(factory configuration)
J10
3
2
1
Not System Controller