Configuring Battery Settings; Battery Number Configuration - KStar MEMO PLUS RT II (MP9100RTII-0.9) 1-3K User Manual

Configuring Battery Settings

S et the UPS for the number of EBPs installed.
0 T
T o ensure maximum battery runtime, configure the UPS for the correct
0 T
n umber of EBPs, refer to Table 8 for the appropriate setting of battery numbers and type.
0 T
Use the up and down scroll keys to select the number of battery strings according to your
UPS configuration:
T able 8 Battery number Configuration
0 T
All UPS and EBP Cabinets
0 T
U PS only (internal batteries)
0 T
0 T
0 T
0 T
0 T
N OTE The UPS contains one battery string; each EBP contains two
0 T
battery strings.
● The following process must be performed if the UPS is connected with generator.
0 T
● First, turn on the generator, after it runs stably connect output power of the
0 T
generator to UPS input terminal, then turn on the UPS. After the UPS is turned on,
please connect load one by one.
● It is recommended that the generator capacity is as twice as the UPS rated capacity.
0 T
● You had better not use the ECO mode when the quality of the input AC mains is not
0 T
good.
UPS+1EBP
UPS+2EBPs
UPS+3EBPs
UPS+4EBPs
CAUTION
Number of Battery Strings
0 T
1（default）
0 T
3
0 T
5
0 T
7
0 T
9
0 T
34