Table of Contents
Advertisement
the top and bottom of the EBP front cover. See Figure
A small amount of arcing may occur when connecting an EBP to the UPS. This is normal and will not
harm personnel. Insert the EBP cable into the UPS battery connector quickly and firmly.
5. Plug the EBP cable(s) into the battery connector(s) as shown in Figure 12. Up to four EBPS may be
connected to the UPS. Connect black to black,. Press the connector tightly together to ensure a
proper connection.
To connect a second EBP, unclip the EBP connector on the first EBP and pull gently to extend the
wiring to the EBP connector on the second EBP. Repeat for any additional EBPS.
6. Verify that the EBP connections are tight and the adequate bend radius and strain relief exist for
each cable.
7. Replace the EBP front cover.
To replace the cover, verify that the EBP cables are routed through the EBP cover knockouts, cover
connects with the cover hook near the left side of the EBP cabinet. Repeat for each additional EBP.
It is the same with the installation of the front cover. (Refer" to UPS installation")
8. Verify that all wires connected between the UPS and EBP(s) are installed behind the front covers
and not accessible to users.
9. Return to Step 4 to continue the UPS installation.
R ackmount converted to Tower
0 T
1.
Rackmount converted to Tower
0 T
CAUTION
Figure12 Typical EBP Installation
Installation
p lastic base installation
0 T
14
12
for the location of the EBP cable knockouts.
Hide quick links:
Advertisement
Table of Contents
