Setting Up An Alarm Station For Alarm Callback - Honeywell Rapid Eye Operator's Manual

Setting Up an Alarm Station for Alarm Callback

Document 800-07767 Rev A
02/11
Note When the View application is shutdown during automatic clip creation, the
alarms will not be automatically rearmed by the application if the automatic
rearming of alarms feature is not selected. Operators will have to manually
rearm alarms with an Alarm session.
Keep the following points in mind when setting up an Alarm Station for alarm callback:
• At any point during alarm callback, only one Alarm Station can have Alarm callbacks
reported at one time even if we have multiple Alarm stations configured for a unit.
Alarm Stations will be notified in the sequence that you setup (see
in the
Stations Rapid Eye™ Multi-Media Digital Video System Administrator
• If an Alarm session is kept open in the Remote View application in any of the user
PCs, then the Alarms are reported in the Alarm session only, rather than to Alarm
Callback stations. Open Alarm sessions take the first priority (see
Priority for Alarm Notification
Guide). If no alarm sessions are open, alarm callbacks will go to the
Administrator
Alarm station.
• If you are trying to change the alarm station, then make sure that you use one of the
following two steps:
a. Update Security for the unit
reboot the unit.
b. Update Security for the unit
alarm generation, disable all of the events reporting alarms)
pending Alarms reported through an alarm session (if necessary)

to 15 seconds
Note The above steps
switching over from the old alarm station to a new alarm station.
Rapid Eye Remote View Operator Guide
in the
Rapid Eye™ Multi-Media Digital Video System

rearm all Alarms reported in the alarm session

make sure no new alarms are generated (to avoid
then try enabling all the events which generates alarms.
and b, are to avoid any racing conditions, between
a
Cascading Alarm
Guide).
Setting Response


rearm any

pause for 10
83