Alarm Setup And Alarm Activation; Go To Alarm Setup Interface; Alarm Setup - Honeywell HSVR-16 User Manual

Figure 4-19 Menu of Camera Masking

Alarm Setup and Alarm Activation

Before operation, make sure you have properly connected alarm devices such as
buzzer.

Go to alarm setup interface

On the main menu, from Setting to Alarm, you can see alarm setup interface. See
Figure

Alarm setup

Alarm interface is shown as below. See
•
•
•
•
•
•
•
30
In "Detect" interface, copy/paste function is only valid for the
Note same type, which means you can not copy a channel setup in
video loss mode to camera masking mode.
4-20.
Alarm in: Here is for you to select alarm input channel number.
Event type: There are two types. One is local input and the other is network
input.
Type: Normally open or normally close.
PTZ activation: Here you can set PTZ movement when alarm occurs. Such as
go to preset, tour& pattern when there is an alarm. Click Select, and you can
see an interface is shown as in
Period: Click Set, and you can see an interface is shown in
you can set for business day and non-business day. In
and you can see an interface shown in
setup for business day and non-business day.
Show message: System can pop up a message to alarm you in the local host
screen if you enabled this function.
Send email: System can send out email to alert you when alarm occurs.
Figure 4-20.
Figure 4-24.
4-26. Here you can set your own
Figure
Honeywell
4-22. Here
Figure
4-25, click Set,
Figure