Symbol Series 3300 System Administration Manual page 68

The range is specified in page numbers (16KB per page). Use the right and left
arrow keys to move between the Start and End values. Use the up and down
arrow keys to change the page number value.
When you have set the range, press Enter.
10. The terminal displays the selected ranges for verification, for example:
RAM 0000 3FFF
NVM C839 DFFF
EMS None
Correct?
If the values are correct, press Enter. If the values are not correct, press Clear
to clear the fields, and then select new values.
11. Specify the baud rate. Use the up and down arrows scroll through the list of
baud rates until the correct rate is displayed, and press Enter. (Flow control
may be necessary at 38400 bps and higher.)
12. Specify the data bits. Press 7 or 8, or use the up and down arrows to display
7 or 8, and press Enter.
If you select 8 data bits, the program selects No parity and skips the next
screen.
13. Specify parity type. If you selected 7 data bits, the 3300 prompts for the parity.
Use the up and down arrows to display a parity option, or press the first letter
of a parity option (Even, Odd, None, Space, or Mark), and press Enter.
14. Set flow control. Use the up and down arrows to display the flow control op-
tions, or you may press the first letter of an option (None, Xon/Xoff, or RTS/
CTS). Then press Enter.
Error Recovery and Troubleshooting
4 - 11