To Turn Off Gas To Appliance; Manual Lighting Procedure - Procom FBD32RT Owner's Operation And Installation Manual

• If control knob does not pop up when
released, contact a qualified service
technician or gas supplier for repairs.
7. With control knob pressed in, push
down and release ignitor button. This
will light pilot. The pilot is attached
to the burner. If needed, keep press-
ing ignitor button until pilot lights.
Note: If pilot does not stay lit, refer to
Troubleshooting, pages 26 though 29.
Also contact a qualified service technician
or gas supplier for repairs. Until repairs
are made, light pilot with match. To light
pilot with match, see Manual Lighting
Procedure.
8. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
Note: If pilot goes out, repeat steps 4
through 8. This heater has a safety inter-
lock system. Wait one (1) minute before
lighting pilot again.
9. Turn control knob counterclockwise
to the ON position. The main burner
should light.
Shutting Off Heater
Turn control knob clockwise
OFF position.
1. Remove screen by lifting and pulling
forward.
2. Follow steps 1 through 6 under Lighting
Instructions, page 20.
3. With control knob in PILOT position, strike
match, and hold near pilot. Press in control
knob; pilot should light.
200069-01A
OPERATION

TO TURN OFF GAS TO APPLIANCE

to the

MANUAL LIGHTING PROCEDURE

www.usaprocom.com
10. Press the LEARN BUTTON on the front
of the remote receiver box until you hear
a beep (see page 21).
11. Press the ON button on the remote control
to light the burner. (This will also "learn",
or program, the remote and the receiver).
Note: If the remote control is lost or dam-
aged, the slide switch on the receiver can
be used to operate the heater.
12. Make sure the heater screen is in place
before operating heater.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
WARNING: If
type is NG, make sure NG pilot
burner ignites. If input gas type
is LP, make sure LP pilot burner
ignites.
Shutting Off Burner Only (pilot
stays lit )
Turn control knob clockwise
PILOT position.
4. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
5. Make sure the heater screen is in place
before operating heater.
input gas
to the
21