Installation - Procom FBD32RT Owner's Operation And Installation Manual

NOTICE: This heater is intended
for use as supplemental heat.
Use this heater along with your
primary heating system. Do not
install this heater as your pri-
mary heat source. If you have a
central heating system, you may
run system's circulating blower
while using heater. This will help
circulate the heat throughout the
house. In the event of a power
outage, you can use this heater
as your primary heat source.
WARNING: A qualified ser-
vice person must install heater.
Follow all local codes.
WARNING: Never install the
heater
• in a bedroom or bathroom
• in a recreational vehicle
• where curtains, furniture,
clothing, or other flammable
objects are less than 42" from
the front, top, or sides of the
heater
• in high traffic areas
• in windy or drafty areas
CAUTION: This heater cre-
ates warm air currents. These
currents move heat to wall sur-
faces next to heater. Installing
heater next to vinyl or cloth wall
coverings or operating heater
where impurities (such as to-
bacco smoke, aromatic candles,
cleaning fluids, oil or kerosene
lamps, etc.) in the air exist, may
cause walls to discolor.
10

INSTALLATION

IMPORTANT: Vent-free heaters add moisture
to the air. Although this is beneficial, installing
heater in rooms without enough ventilation air
may cause mildew to form too much moisture.
See Air for Combustion and Ventilation, pages
7 through 9.
Be sure your gas supply is right for your heat-
er. Otherwise, call dealer where you bought
the heater for proper type heater.
tain the minimum clearances
shown in Figure 4. If you can,
provide greater clearances from
floor, ceiling, and joining wall.
Measure from outermost point
of heater.
A. Clearances from outermost point of heater
to any combustible side wall should not be
less than 7".
B. Clearances from the heater to the ceiling
should not be less than 42".
Note: When heater is installed directly on
carpeting, vinyl or other combustible material,
other than wood flooring, the heater must be
installed on a metal or wood panel extending
the full width and depth of the heater.
Side
Wall
Figure 4 - Minimum Clearances to Wall
www.usaprocom.com
CHECK GAS TYPE
CLEARANCES TO
COMBUSTIBLES
WARNING: You must main-
Minimum Wall and Ceiling
Clearances
Ceiling
42"
7"
Min.
Min.
Front View
and Ceiling
7"
Min.
Side
Wall
200069-01A