Remote Control System; Remote Control Operation - Procom FBD32RT Owner's Operation And Installation Manual

Programming the Remote and Receiver
The remote and receiver must be "learned"
to one another.
1. Turn control knob on the heater to the ON
position.
2. Place the slide switch on the receiver in
the remote position (see Figure 25).
3. Use a pen or small screwdriver to gently
press and release the recessed LEARN
button on the face of the receiver. You will
hear a beep.
4. Press the ON button on the remote (see
Figure 26). You will hear a series of beeps.
Your appliance should come on.
Learn Button
LEARN
ON
Slide Switch
Figure 25 - Receiver

Remote Control Operation

This appliance must not be used with glass
doors in the closed position. This can lead
to pilot outages and severe sooting outside
the fireplace.
The transmitter operates on 2 AAA batteries.
22
OPERATION

REMOTE CONTROL SYSTEM

REMOTE OFF
www.usaprocom.com
Key Settings
ON - Operates unit to on position, manually
operated solenoid ON.
OFF - Operates unit to off position, manually
operated solenoid OFF.
MODE - Changes unit from manual mode to
thermo mode.
SET - Sets temperature in thermo mode.
Figure 26 - Remote Control
LCD Liquid Crystal Display
1. DISPLAY Indicates CURRENT room
temperature.
2. °F or °C Indicates degrees Fahrenheit or
Celsius.
3. FLAME Indicates burner/valve in operation.
4. ROOM Indicates remote is in THERMO
operation.
5. TEMP Appears during manual operation.
6. SET Appears during time the of setting
the desired temperature in the thermo
operation.
1
4
ROOM SET TEMP
Figure 27 - Remote Control Display
TEMP
2
3
5
6
200069-01A