Procom FBD32RT Owner's Operation And Installation Manual page 18

WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installation,
and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to high, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
1
3
18
INSTALLATION
INSTALLING LOGS
2
4
Figure 21 - Installing Logs
www.usaprocom.com
Each log is marked with a number. This
number will help you to identify the logs when
installing.
After installing logs, add decorative cinders
around the grate base, do not place any
decorative cinders on logs or burner.
IMPORTANT: Make sure logs do not cover
any burner ports. It is very important to install
the logs exactly as instructed. Do not modify
logs. Use only logs supplied with heater.
Logs 1 through 6 have pins on the back that
slide into the slots in the base brackets.
Some logs may have pins that fit into holes on
another log. This helps keep them in place.
Rear
Bracket
Slot in Bracket
Figure 20 - Log Base
5
7
Middle
Bracket
Front
Bracket
6
8
9
200069-01A