Gas Supply - Procom FBD32RT Owner's Operation And Installation Manual

This appliance is factory
preset for propane/LP gas.
No changes are required for
connecting to propane/LP.
Only a qualified installer or
service technician can perform
gas selection and connecting to

gas supply.

CAUTION: Two gas line in-
stallations at the same time are
prohibited. The access plate
to the simple switching means
shall not be opened while the
heater is in operation.
CAUTION: To avoid gas
leakage at the inlet of regulator,
a qualified installer or service
technician must use supplied
hex plug with sealant.
WARNING: Do not attempt to
access or change the setting of
the fuel selection means.
Access to and adjustment of the fuel selection
means must only be performed by a qualified
service person when connecting this appliance to
a specified fuel supply at the time of installation.
Change of the selector setting to other than
the fuel type specified at the time of installa-
tion could damage this appliance and render
it inoperable.
The installer shall replace the access cover
before completing the installation and operat-
ing this appliance.
For changing from propane to
natural gas supply:
1. Remove 2 screws from cover plate to
expose fuel selection device (see Figure
14, page 15).
2. For NATURAL GAS, press in knob using
a flat screwdriver with a blade with thick-
ness of a quarter and turn knob clockwise
until the knob locks into the NG po-
sition (see Figure 5). Fuel selection device
200069-01A
INSTALLATION
GAS SELECTION
must be locked in the NG position. Do not
operate heater between locked positions!
3. Rotate and close cover over fuel selection
device and reinstall screw.
4. Remove hex plug (with wrench provided)
from natural gas inlet of regulator (see
Figure 5). Install gas line into NG inlet of
regulator. Use thread sealant to assure
there are no leaks.
Gas Connection Fitting
Hex Plug
Figure 5 - Settings for Natural Gas
For changing from natural gas
1. Remove 2 screws from cover plate to
expose fuel selection device (see Figure
14, page 15).
2. For propane gas, press in knob using a flat
screwdriver with a blade the thickness of
a quarter and turn knob counterclockwise
tion (see Figure 6). Fuel selection device
must be locked in the LP position. Do not
operate heater between locked positions.
3. Rotate and close cover over fuel selection
device and reinstall screw.
4. Remove hex plug (with wrench provided)
from propane/LP gas inlet of regulator
(see Figure 6). Install gas line into LP inlet
of regulator. Use thread sealant to assure
there are no leaks.
Hex Plug
Gas Connection Fitting
Figure 6 - Settings for Propane/LP Gas
www.usaprocom.com
NG
Gas Inlet
Gas esté
LP
Fuel Selector Knob
Selection
supply to propane supply:
until the knob locks into the LP posi-
NG
Gas Inlet
Gas esté
LP
Fuel Selector Knob
Selection
LP
NG
Gas Select
Selector de gas
LP
NG
Gas Select
Selector de gas
11