Replacing The Inlet Valve - VKI Technologies Eccellenza Express Service Manual

Replacing the Inlet Valve

NOTE: The inlet valve consists of an assembly of hoses, fittings and a backflow
prevention valve secured together by Oetiker (circle) clamps. To replace any
component on this assembly, existing clamps will need to be broken using cutters.
New clamps must be installed when re-assembling the inlet valve components.
1. Switch the machine power off and unplug the service cord.
2. Disconnect the water supply and drain the water tank.
3. Remove the left side panel
4. Disconnect the two power wires from the inlet valve.
5. Remove the Oetiker circle clamp securing the tubing assembly to the inlet
valve.
6. At the rear of the machine, remove the two screws securing the inlet valve to
the rear wall of the machine. The valve can now be completely removed.
7. Secure the new inlet valve to the rear of the machine with two screws.
July 15, 2015
.
(see page 13)
Eccellenza Express – Service Manual
47