Replacing Main Power Components; Fuse Holder (5 Amp Or 15 Amp) - VKI Technologies Eccellenza Express Service Manual

Replacing Main Power Components

The service cord must be disconnected from the wall outlet
when servicing these components. They remain live even when
the main power is switched off at the rear of the machine.
The main power components are all secured to the rear of the machine, under the rear
service panel. Opening this panel provides access to the two fuse holders, the power
supply, the main power switch and the main power plug for the service cord. To access
these components, the rear panel must be opened

Fuse Holder (5 Amp or 15 Amp)

Both of the fuse holders are located at the top rear of the Eccellenza Express. To
replace either of the fuse holders:
1. Disconnect the wiring from the fuse holder.
2. Loosen the plastic hex nut that secures the fuse holder to the main power plate.
3. Pull the fuse holder out through the top of the machine.
4. Transfer the fuse and the cap from the old fuse holder onto the new one (if
required).
5. Install the new fuse holder and secure it in place with the hex nut.
6. Connect the wiring to the new fuse holder.
July 15, 2015
Eccellenza Express – Service Manual
.
(see page 14)
59