Chapter 2 Getting Started; Installing On A Network; Assigning An Ip Address - GeoVision VSV13-A-EN User Manual

Chapter 2 Getting Started

This section provides basic information to get the GV-Video Server working on the network.

2.1 Installing on a Network

These instructions describe the basic connections to install the GV-Video Server on the
network.
1. Connect your camera's video output to the BNC video input.
2. Connect your audio source to the RCA audio input.
3. Connect the hub or switch on the LAN to the unit's 10/100 Mbps Ethernet port.
4. Connect the power supply to the power input.
Wait until the Power and Ready LED is on and then you can set the IP address for the unit.

2.2 Assigning an IP Address

Designed for use on an Ethernet network, the GV-Video Server must be assigned an IP
address to make it accessible.
Note: The GV-Video Server has a default address of 192.168.0.10. The computer used to
set the IP address must be under the same IP and subnet sequence assigned to the unit.
4
1
3
Figure 2-1
2
4