Chapter 9 The I/O Terminal Block - GeoVision VSV13-A-EN User Manual

Chapter 9 The I/O Terminal Block

The 16-pin Terminal Block, located on the rear panel, provides the interface to: four digital
inputs, four relay outputs, an RS-485 interface, a Wiegand interface and auxiliary power.
The I/O Terminal Block can be used to develop applications for motion detection, event
alerts via E-mail and FTP, center monitoring by Center V2 and VSM, PTZ control,
Wiegand-interface card reader and a variety of other functions.
Pin Assignment
The pin assignment for the Terminal Block is described in the table below.
Pin Function
1 Relay Output 1
2 Digital Input 1
3 Relay Output 2
4 Digital Input 2
5 Relay Output 3
6 Digital Input 3
7 Relay Output 4
8 Digital Input 4
70
Figure 9-1
Pin Function
9 DC 5V Out for GV-Relay Module
10 Ground
11 RS 485+
12 Wiegand D0
13 RS 485-
14 Wiegand D1
15 Ground
16 DC 12V Out for Wiegand Card Reader