Chapter 2 Getting Started; Installing On A Network; Assigning An Ip Address - GeoVision GV-VS01 Manual

Chapter 2 Getting Started

2.1 Installing on a Network

These instructions describe the basic connections to install the GV-Video Server on the
network.
1. Connect your camera's video output to the BNC video input.
2. Connect your audio source to the RCA audio input.
3. Connect the hub or switch on the LAN to the unit's 10/100 Mbps Ethernet port.
4. Connect the power supply.
Wait until the Power and Ready LED is on and then you can set the IP address for the unit.

2.2 Assigning an IP Address

The GV-Video Server is designed for use on an Ethernet network and must be assigned
an IP address to make it accessible.
Note: The GV-Video Server has a default address of 192.168.0.10. The computer used to
set the IP address must be under same IP and subnet sequence assigned to the unit.
4
1
3
Figure 2-1
2
4