Table of Contents
Advertisement
Chapter 3 Getting Started
3.1 Basic Installation
This section describes all the equipment required to program and operate GV-Tower
NVR/VMS System V2 (Rev. C). Here we use GV-Tower NVR System V2 (Rev. C) as the
example.
1.
Connect an HDTV to GV-Tower NVR/VMS System V2 (Rev. C) using the HDMI / VGA /
DVI-D cable supplied by the HDTV manufacturer.
2.
Using the RJ-45 cable, connect one end to the Ethernet port and the other end to
Network.
3.
Connect speakers to the Audio Line Out port.
4.
Connect the mouse and keyboard to the USB port (either USB2.0 or USB(3.1 Gen 1)
port) or the PS/2 mouse / keyboard port.
5.
Using the supplied power cord, connect one end to the AC input and the other end to the
power outlet.
Once the above hardware is properly connected, press the Power button on the front panel to
start the system. It takes about 1 minute for startup. The system should load automatically and
display cameras in the main screen.
Figure 3-1
Getting Started
3
7
Advertisement
Table of Contents
