Digital I/O & Ptz; Ptz Settings - GeoVision VSV13-A-EN User Manual

4.2 Digital I/O & PTZ
The I/O terminal block, on the rear panel of the GV-Video Server, has 16 pins for device
control. These pins can be divided into three categories based on the interface being used:
1. Digital Input / Relay Output
2. RS-485 interface for PTZ control
3. Wiegand interface for access control

4.2.1 PTZ Settings

Through the RS-485 interface on the I/O terminal block, you can connect up to 2 PTZ
cameras. Consult your PTZ documentation to set up the baud rate, speed and address.
Note: Currently the GV-Video Server doesn't support the PTZ camera with RS-232
interface.
Figure 4-7
Administrator Mode
4
23