Coolant Fluid Pump Removal/Installation - Husqvarna TR 650 TERRA 2013 Workshop Manual

GENERAL ENGINE PROCEDURES
TR 650 TERRA 2013 - TR 650 STRADA 2013
1
2
3
7
8
6

COOLANT FLUID PUMP REMOVAL/INSTALLATION

- Remove the pump cover and left cover as described in the relevant paragraph.
Removal:
- Remove the transmission sprocket (1) of the pump shaft.
- Remove the pin (2) paying attention to the washer (3).
- Extract the impeller (4) with the pin (5) and shaft (6).
- Extract the seal rings (7) and (8) from the left cover.
Installation:
- Check for any signs of wear on the shaft (6) Check the seal rings; replace if
necessary. If replacing the sealing rings or shaft, be sure to replace both in
tandem.
- Insert the sealing ring (7) into the seat of the left cover (use a suitable tool).
- Fill the gaps between the sealing rings with lubricant grease (use Molycote
111).
- Insert the sealing ring (8), using a suitable tool, until the outer lip touches the
edge of the left cover.
- Check that the impeller (4) is not damaged, mount onto the shaft (6) and
secure with the pin (5).
- Mount the shaft (6) and impeller inside the left cover.
- Fit the washer (3).
- Install the pin (2) into the shaft (6) of the pump.
- Mount the transmission sprocket (1) onto the shaft (6) by connecting it to the
pin (2).
7
8
5
F1.19
6
4
Workshop Manual Ed.09-2012
H11567