Husqvarna TR 650 TERRA 2013 Workshop Manual page 96

1
4
3
5
4
6
Workshop Manual Ed.09-2012
CRANKCASE DISASSEMBLY
TR 650 TERRA 2013 - TR 650 STRADA 2013
CRANKCASE DISASSEMBLY
Crankcase disassembly:
- Remove the starter motor.
- Remove the flywheel.
- Remove the starter motor idle gear.
- Remove the chain sprocket.
- Remove the coolant pump cover.
- Remove the complete clutch.
- Remove the drive gear and the oil pump gears.
- Remove the transmission gear for the coolant pump
- Remove the cylinder and piston.
Refer to the relevant paragraphs/chapters for the removal operations.
Disassembly:
- Remove the screws (1).
- Disassemble the oil filter cover (2) and the filter.
2
1
H11606
- Disassemble the switch (3) of the neutral position.
- Undo screws (4) and (5)
4
4
- Position the engine with left crankcase side (clutch side) facing upwards.
H11607
- Tighten the knurled screws (6).
- Lift the left engine cover, beat alternately with light blows (plastic mallet) on
the main shaft and countershaft transmission, so that they remain on the
right crankcase.
H11608
When refitting correctly position the relevant housing in the screws (4)
and (5) as they are of two different lengths:
Screws 4= 45 mm (1.77 in.).
Screws 5= 75 mm (2.95 in.).
The bearings may be damaged if the crankcase is not disassembled/
assembled vertically.
Do not rock the engine crankcase during disassembly and assembly.
F3.6