Husqvarna TR 650 TERRA 2013 Workshop Manual page 89

TR 650 TERRA 2013 - TR 650 STRADA 2013
9
6
1 F
3
D
CYLINDER HEAD REMOVAL/DISASSEMBLY
- Remove the gasket (8).
Installation:
10
- Clean the sealing surfaces and eliminate all traces of oil and grease.
- Replace the gasket (8) and position it on the cylinder.
8
- Pull the timing chain (9) through the well.
- Mount the cylinder head (7) while paying attention not to damage the timing
chain (9) and the chain tensioner slider (10).
H11585
- Tighten the screws (6) in a cross pattern with a first pre-tightening torque,
then tighten with a final specified torque.
H11586
- Tighten the screws (1), (2), (3), (4) and (5) without securing them.
- Tighten the screws (1), (2), (3), (4), and (5) at the torque specified, according
to sequence A to F as shown in the figure.
- Reassemble all parts previously removed, in the reverse order compared to
disassembly, as in the relative paragraphs.
2
A
H11587
4
E
4
B
H11588
F2.9
5
C
H11589
Workshop Manual Ed.09-2012