Removal/Installation Or Replacement Of The Timing Chain - Husqvarna TR 650 TERRA 2013 Workshop Manual

5
4
2
Workshop Manual Ed.09-2012
GENERAL ENGINE PROCEDURES
TR 650 TERRA 2013 - TR 650 STRADA 2013

REMOVAL/INSTALLATION OR REPLACEMENT OF THE TIMING CHAIN

- Remove the head cover and the camshafts as described in the relevant
paragraphs.
- Fix the timing chain with metal wire so that it does not slip into the engine.
- Remove the left cover as described in the relevant paragraph.
- Unscrew the nut (1) and remove the spring washer (2).
- Press the chain tensioner towards the rear of the engine (3).
- Remove the dual gearbox (4) from the shaft and remove the timing chain (5).
- Check the chain tensioner slide (3) for wear, replace if worn by undoing screw
(6).
3
- Insert the timing chain (5) into the recess and position it around the crankshaft,
6
push towards the chain tensioner slider (3) rear of the engine.
- Mount the dual gearbox (4) onto the crankshaft.
- Fit the chain (5) onto the dual gearbox (4).
- Fit the split washer (2).
1
- Clean the threads of crankshaft and hex nut (1).
- Tighten the nut (1) to torque with Loctite 243.
- Refit all the previously removed components as described in the relevant
H11568
paragraph and perform phasing operations.
F1.20