Table of Contents
Advertisement
If you keep holding the THRESHOLD button, then during the next
two seconds the dosimeter will proceed to the submode of programming of
new values of alarm threshold level and specified statistical error, and
switching on/off audio signaling of registered gamma-quanta (Figure 7). A
stripe (1) "moving" across the instantaneous value indicator and blinking of
the low-order digit (2) of a new threshold level serve as an indication of this
submode. Then release the THRESHOLD button.
When a digit is blinking, it means that its value can be programmed.
Use the THRESHOLD button to set the required value of the blinking digit.
Successive short presses and releases of the THRESHOLD button change
this value per unit. A long press of the THRESHOLD button starts
automatic change of this value, which is stopped after the button is released.
49
Advertisement
Table of Contents
