Table of Contents
Advertisement
2.2.3.2 Press shortly the MODE button and make sure the dosimeter
has entered the mode of indication of photon-ionizing radiation DE
accumulated value. "γ" symbol and "mSv" dimension of the measured
quantity show that the dosimeter is operating in this mode.
2.2.3.3 Press shortly the MODE button and make sure the dosimeter
enters the mode of surface beta-particles flux density measurement. "β"
symbol and "
(
cm
dosimeter is operating in this mode.
2.2.3.4 Press and hold (circa 6 seconds) the MODE button until the
dosimeter turns off.
2.2.4 List of possible troubles and troubleshooting
2.2.4.1 The list of possible troubles and troubleshooting is presented in
Table 2.2. Troubles during use are recorded in Appendix E of this OM.
2.2.4.2 At failure to eliminate the troubles presented in Table 2.2, or at
detection of more complicated troubles, the dosimeter should be sent for
repair to the manufacturer.
3
10
" dimension of the measured quantity show that the
2
min)
28
Advertisement
Table of Contents
