Serial Port Settings; 5.10.1. Serial Port - Logic Data Systems L-5500 Manual

Broadband cellular router
Table of Contents

Advertisement

Minimum: When a sensor value drops below this parameter, a position report is
immediately transmitted (regardless of time-distance formula).
Maximum: When a sensor value exceeds this parameter, a position report is immediately
transmitted (regardless of time-distance formula).
5.10.

Serial Port Settings

The following settings allow local or remote GPS reports to be sent out to the user COM
port.
Figure 34 – Serial Port Settings

5.10.1. Serial Port

5.10.1.1.
GPS Configuration
The serial port settings are disabled by default. To enable GPS reports to be sent out to the
user COM port, select "GPS". The GPS reports could be sent over the serial port "Always" or
only "On Loss of Cellular Signal".
Note that the following delays apply if the latter is selected:
On power-up: Reports are delayed for 90 seconds to allow time for cellular connectivity to
be established.
Page 50

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the L-5500 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents