Sensor Reporting - Logic Data Systems L-5500 Manual

Broadband cellular router
Table of Contents

Advertisement

TAIP with ID: Same as above except with the Vehicle ID reported.
NMEA: NMEA 0183 Protocol. When selected, a checkbox appears for selecting the
following sentence formats: GLL, GGA, RMC, VTG.
UDP Host Address: IP address of local PC that GPS data will be delivered to. This address
must be on the same subnet as the L-5500 LAN IP. To broadcast addresses across the
entire subnet, enter the IP address in the form 192.168.1.255.
UDP Host Port: Port assigned to UDP program. This must match the port assigned in the
chosen UDP Port Listener Program.
5.9.2.2.
Remote Delivery
The GPS data can be delivered to up to three remote hosts.
Report every: GPS can be programmed to report position after a specified time has
elapsed or the unit has moved a specified distance since its last report. This field indicates
the maximum length of time or distance that can elapse between position reports.
But no less than: This feature prevents a fast moving vehicle from reporting too frequently
if its "Report every ..... meters" setting is sufficiently low by setting a minimum amount of
time, in seconds, between GPS reports.
The remaining fields are the same as what's listed in Section 5.9.2.1.
5.9.3.

Sensor Reporting

The L-5500 is capable of reporting the status of sensors when the Logic Data Systems
protocol is configured under the remote reporting section of the AAVL Settings page. The
Sensor Reporting page enables configuration of how sensor values are reported.
Page 48

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the L-5500 and is the answer not in the manual?

Table of Contents