Advanced Settings - Remote Admin; Advanced Settings - Power Management - Logic Data Systems L-5500 Manual

Broadband cellular router
Table of Contents

Advertisement

5.7.5.
Advanced Settings – Remote Admin
Figure 29 – Advanced Settings -> Remote Admin page
Remote Configure: Selecting Enable will allow remote access to the modem's
configuration screens through the cellular network connection. Selecting Disable will shut off
the ability to remotely access the modem's configuration screens.
Incoming Port: Change the port of incoming requests. It is not necessary to change this
parameter unless it conflicts with other devices on the network.
Admin Password: Set the password for BOTH remote login and local login. The password
must be entered twice for the password to change.
5.7.6.
Advanced Settings – Power Management
Figure 30 – Advanced Settings -> Power Management section
The L-5500 unit is designed to stay ON even if the ignition is turned OFF. You can configure
your L-5500 unit to automatically shut down 15, 30, 60, 240, or 3600 minutes after ignition
is turned off or when the supply voltage drops to a certain level.
Shutdown Method: Disabled by default (unit always ON after ignition is turned OFF).
Select "Power Off" to enable power management.
After ignition line off: Select between the following time intervals: 15 minutes, 30
minutes, 60 minutes, 4 hours, or 24 hours.
When Voltage Drops to: Enter desired voltage. Enter "0" to disable. (Note: A value of 11V
would be usually entered here as a precaution in order to ensure the vehicle battery does
not drain.)
Page 43

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the L-5500 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents