Provisioning The L-5500 Radio Modem - Logic Data Systems L-5500 Manual

4.4.

Provisioning the L-5500 Radio Modem

IMPORTANT NOTE:
The L-5500 cellular radio modem requires an active cellular data service contract
for provisioning. Verify that your cellular service contract is a data service
contract with packet data NOT circuit switched technology. If you do not have an
active data contract, contact your service provider.
Depending on your carrier, the L-5500 radio modem can be activated manually (see Figure
6) or using OTASP (Over-The-Air Service Programming) or IOTA (Internet Over-The-Air)
(see Figure 6). In either case, the carrier will require you to provide them with the MEID
that is assigned to the cellular modem at the factory. You can see your MEID by selecting
the Cellular (WAN) page -> "Status" tab or on the label on the bottom of your L-5500 unit.
Figure 5 - L-5500 radio modem Home page
Page 14