Power Cord Set Requirements; General Requirements - Compaq StorageWorks Installation Manual

The power cord set meets the requirements for use in the country where you
purchased your equipment. The voltage selection switch allows you to select
the appropriate line voltage for your server.
Power cord sets for use in other countries must meet the requirements of the
country where you use the server. For more information on power cord set
requirements, contact your Authorized Compaq Dealer.

General Requirements

The requirements listed below are applicable to all countries:
The length of the power cord must be at least 6.00 feet (1.8 m) and a
maximum of 12 feet (3.6 m).
The power cord set must be approved by an acceptable accredited agency
responsible for evaluation in the country where the power cord will be
used.
The power cord set must have a minimum current capacity and nominal
voltage rating of 10A/125 volts AC or 10A/250 volts AC, as required by
each country's power system.
The appliance coupler must meet the mechanical configuration of an EN
60320/IEC 320 standard sheet C13 connector for mating with the
appliance inlet on the computer.
Compaq Confidential – Need to Know Required
Writer: Susan Caesar Project: Compaq StorageWorks Fibre Channel Storage Hub 12 Installtion Guide Comments:
Part Number: 340662-002 File Name: g-appc Power Cord Set Requirements.doc Last Saved On: 4/16/99 8:29 AM

Power Cord Set Requirements

C
Appendix