Stacking - Blodgett COS-6 Installation, Operation And Maintenance Manual

TO STACK TWO COS-6'S OR ONE COS-6 ON A
COS-101:
1. Install the 6" legs as directed.
2. Center a COS-6 unit on top of the lower sec-
tion.
3. Remove the screws from the rear access pan-
el and remove the access panel from the bot-
tom unit.
4. Carefully remove the fan plug and disas-
semble the steam vent.
NOTE: The fan plug connector can be easily
damaged
5. Align the two rear bolt holes in the lower sec-
tion with the two threaded holes in the upper
section.
6. Insert a bolt from the bottom up through each
of the two holes and tighten securely.
7. Reassemble the steam vent and reconnect
the fan plug. Reinstall the rear access panel
on the lower unit.
COS-6 on either
another COS-6 or a COS-101
Figure 8
TO STACK A COS-6 ON A COS-101S:
1. Install the 6" legs as directed.
2. Place the COS-6 on top of the COS-101S.
Make sure that the front and left hand side of
the COS-6 line up evenly with the front and left
hand side of the COS-101S.
3. Remove the left side access panel from the
lower unit.
4. Thread one of the two supplied bolts up
through the COS-101S's top rear frame mem-
ber and into the bottom left rear corner of the
COS-6.
5. Thread the second bolt down through the bot-
tom rear frame member of the COS-6 into the
nut welded to the frame member of the
COS-101S.
COS-6 on a COS-101S
11
Installation

Stacking

Figure 9