Stacking The Ovens (If Applicable) - Blodgett SG2136E Installation Operation & Maintenance

Table of Contents

Advertisement

Available languages

Available languages

STACKING THE OVENS (if applicable)

1. Install the supports on the bottom unit as de-
scribed.
2. Have several persons carefully lift the oven off
the pallet and set it onto the casters.
3. Engage the brakes on the front casters.
4. Rest the top oven on its back. Install the four
oven alignment pins into the nuts on the bot-
tom of the upper oven. The pointed end of the
pin will go through the stacking rails and into
the holes on top of the lower oven.
5. Lay the stacking rails on top of the lower oven.
The holes in the rails should line up with the
holes in the oven.
6. For ovens with integral computers, mount
each heat shield bracket to the bottom of the
control tunnel of the top oven with the open
end facing out.
Alignment
Oven
Pin
Stacking
Rails
7. Attach the control box stacking spacer as fol-
lows:
a.) Place the control box stacking spacer on
top of the control box of the bottom unit.
b.) Loosen the two screws at the top of the
rear of the control box of the lower oven.
c.) Slide the stacking trim over the loosened
screws. Tighten the screws.
d.) Attach the stacking trim to the side of the
stacking spacer with the screws provided.
8. Have several persons carefully place the up-
per oven on top of the lower oven. Align the
alignment pins with the holes in the top of the
lower oven.
9. For ovens with integral computers, slide the
front heat shield into the heat shield support.
Heat Shield Bracket
Stacking Rails
Stacking Trim
Figure 5
9
Installation
Oven Assembly
Oven
Alignment
Pin
Heat
Shield
Control Box
Stacking Spacer

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sg2136gSg2136g/aaSg2136e/aa

Table of Contents