Decalcification - Blodgett COS-6 Installation, Operation And Maintenance Manual

1. Turn the Mode Selection Switch (1) to the
STEAM mode. Wait until steam is produced.
This will ensure that the water in the steam
generator is hot.
2. Turn the Mode Selection Switch (1) to the
COOL DOWN mode and leave the door open.
Let the oven compartment cool to 150_F
(66_C). This ensures that the Drain/Flush
switch will function in STEP 8.
3. Turn the Mode Selection Switch (1) to OFF.
4. In a suitable size container, mix together the
deliming solution and hot tap water. Refer to
the following chart for the proper mixture:
Deliming
Model Solution
COS-6 12 oz.
COS-101 18 oz.
COS-101S 18 oz.
NOTE: These volumes are approximate. You
may need more or less hot water de-
pending on your site.
5. Remove the Deliming Port Cap from the De-
liming Inlet (5). Attach the supplied Funnel
and Hose Assembly (3) to the deliming inlet.
6. Open the Deliming Port Valve (2) and pour in
the deliming mixture. Stop pouring when the
funnel stops draining. This is the correct
amount for your site.
Hot Tap Water
3 quarts
1-1/4 gallons
1-1/4 gallons
23
Maintenance
7. Shut the Deliming Port Valve (2). Screw on the
Deliming Port Cap. Let the mixture stand for 20
minutes. In areas of the country with hard wa-
ter, allow the mixture to stand for 1 hour.
8. Depress and hold the Drain/Flush Switch (4)
in the FLUSH position for 90 seconds. This
completes the deliming procedure.
3
open
2
close
1
Figure 16

Decalcification

5
4