Stacking - Blodgett COS-6 Installation And Operation Manual

Installation

Stacking

To Stack a COS-6 on a COS-6, a COS-101 on a
COS-101 or a COS-6 on a COS-101:
1. Install the 152,4mm (6") legs as directed.
2. Center a COS-6 unit on top of the lower sec-
tion.
3. Remove the screws from the rear access pan-
el and remove the access panel from the bot-
tom unit.
4. Carefully remove the fan plug and disas-
semble the steam vent.
NOTE: The fan plug connector can be easily
damaged
5. Align the two rear bolt holes in the lower sec-
tion with the two threaded holes in the upper
section.
6. Insert a bolt from the bottom up through each
of the two holes and tighten securely.
7. Reassemble the steam vent and reconnect
the fan plug. Reinstall the rear access panel
on the lower unit.
COS-6 on either another COS-6 or a COS-101
and a COS-101 on a COS-101
To stack a COS-6 on a COS-101s
1. Install the 152,4mm (6") legs as directed.
2. Place the COS-6 on top of the COS-101S.
Make sure that the front and left hand side of
the COS-6 line up evenly with the front and left
hand side of the COS-101S.
3. Remove the left side access panel from the
lower unit.
4. Thread one of the two supplied bolts up
through the top rear frame member of the
COS-101 and into the bottom left rear corner
of the COS-6.
5. Thread the second bolt down through the bot-
tom rear frame member of the COS-6 into the
nut welded to the frame member of the
COS-101S.
COS-6 on a COS-101S
Figure 6
8