Operating with other devices
Transferring the call before/after answering
either ...
S ~
a
or ...
S ~
a
i
Information about telephoning with devices on an analogue connection
can be found in the operating instructions of your base.
Activating/deactivating repeater mode
You can increase the range of your handsets with the Gigaset Repeater. You can operate
up to six repeaters on your base. To ensure the repeater is installed correctly, repeater
mode must be activated on the base.
You can use this function to activate and deactivate repeater mode.
By factory default, this repeater capability is deactivated.
v
s í
s
Settings
~
OK
s
System settings
s
Spec. function
s
Repeater
[RRRRRRRRRRRRRRRRRRRRRRRRRRR]
NEXT
136
Transferring before answering:
Hold down (return to idle status).
Transferring after answering:
Transfer the call after answering.
Make an enquiry call.
Hold down (return to idle status).
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN if required (page 91).
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Press the display key to save the setting. The handset
goes off briefly (
‰
= activated).