Setting Up Automatic Call Forwarding When Not Reaching A Handset; Setting Up An Internal Group Call Group - Siemens Gigaset C1 User Manual

System settings

Setting up automatic call forwarding when not reaching a handset

If your handset is out of the radio range of the base station, the battery is flat, or the
handset has been deactivated, a call will be forwarded to one of the external phone
numbers you specify (e.g. a mobile phone).
Preconditions:
You have exclusively assigned the handset its own incoming MSN (page 113). This
◆
MSN must not be assigned as the incoming MSN for any other device, not even the
ISDN bus!
Call forwarding can only be set up for one incoming MSN on the base.
◆
By factory default, automatic call forwarding is not set up.
v
s í
s
Settings
~
OK
s
ISDN settings
s
Auto.forwarding
s
v
~
Í
s
Save entry
The line set up for automatic call forwarding is marked in the list of set-up call forward-
ing lines.

Setting up an internal group call group

You can make a group call from any handset to all other registered internal party
(page 23).
In the basic settings, all registered parties of device type "telephone" or "neutral" are set
up in the group call group.
v
s í
s
Settings
~
OK
s
Setup user
s
Setup device
s
Int.11
122
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN if required (page 91).
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Select call fowarding line, e.g. MSN1: Anna.
Open the submenu.
Enter "call to" number and confirm.
Select the menu item and confirm. Automatic call
OK
forwarding is activated (
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN if required (page 91).
Select the menu item and confirm.
OK
Confirm.
OK
Select internal number, e.g. Int.11 .
‰
= on).