Appendix; Care; Contact With Liquid; Questions And Answers - Siemens Gigaset C1 User Manual

Appendix

Care

Wipe the handset with a damp cloth (use no solvent) or an antistatic cloth. Never use
a dry cloth. This can cause static.

Contact with liquid

If the handset should come into contact with liquid, on no account switch the device
on. Remove all batteries immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.

Questions and Answers

If you have any questions about the use of your phone, you can contact us 24/7 at
www.siemens-mobile.com/custeromercare. You will find the most frequently asked
questions and answers below.
What has happened
when ...
... the display is blank?
... the handset fails to respond
to a key press?
... Base or Base Search
flashes in the display?
... the handset does not ring? The ringer is switched off.
... the call units/charges are
not displayed?
... the incoming call number is
not displayed even though
CLIP is set?
... the calls list does not indi-
cate a time for a message?
!
Possible cause
The handset is not switched on.
The batteries are flat.
The keypad lock is activated.
The handset is outside the range
of the base.
The handset is not registered.
The base is not switched on.
Internal call forwarding is set to 0
rings (= immediate call forward-
ing).
Night service is active.
There are no metering pulses.
Factor per unit = 0.
Calling Line Identification is
blocked.
Date/time are not set.
Appendix
Possible solution
a
Press the end call key
around 2 sec.
Charge or replace the batteries
(page 9).
R
Press the hash key
around 2 seconds to deacti-
vate the lock (page 10).
Move the handset nearer to the
base.
Register the handset (see
page 9 and page 20).
Check the power connector at
the base.
Activate the ringer of the hand-
set (page 107).
Increase the number of rings
for the internal call forwarding
(page 117).
Deactivate Night service
(page 98).
Ask your network provider to
transmit the metering pulses.
Set the factor per unit
(page 73).
The caller must ask his network
provider to enable the identifi-
cation of his number (CLI).
Set the date/time (page 94).
for
for
151