Reviewing A Data Field/Erasing An Entry; Interactive Mode Programming ( ✱ 56, ✱ 58, ✱ 80, ✱ 81, And ✱ 82); Loading Factory Defaults; Programming System Setup Fields - ADEMCO
Vista-15 Installation And Setup Manual

VISTA-15/VISTA-15CN Installation and Setup Guide
3. If the number of digits that you need to enter in a data field is less than the maximum digits
available (for example, the phone number field), enter the desired data, then press [
data field number to be programmed.
4. If you try to enter a nonexistent field, the keypad will display EE or ENTRY ERROR. Simply re-
enter [

Reviewing a Data Field/Erasing an Entry

Press [#] + Field No. Data is displayed for that field number. No changes are accepted in this
mode.
To delete an entry in a field, press [
Interactive Mode Programming (
Typical prompt displayed
during Interactive mode
programming:
Enter Zn Num.
(00 = Quit)

Loading Factory Defaults

To load the factory defaults, enter the Programming mode, press
Do not press ✱ 97 to load defaults if any programming has been done previously—data already programmed
into the system will be changed!
✱
96 resets all the subscriber account numbers and CSID in preparation for an initial download.

Programming System Setup Fields

The following program fields must be programmed before doing any zone programming:
FIELD TITLE and DATA ENTRIES
RF System
*22
0 = no RF receiver used
1 = 5881/5882 RF receiver used without RF Jam
Detection
4 = 5800 with RF Jam Detection
Wired Zone Expansion
*25
0 = no expander module connected
1 = 4219 connected
2 = 4229 connected
3 = 4204 connected

Exiting the Programming Mode

✱
99 allows re-entry into the Program mode using Installer Code + 8 0 0 .
✱
98 prevents re-entry into the Programming mode using the Installer code.
3–2
✱
] plus a valid field number.
✱ 56, ✱ 58,
Press [
keypad displays the first of a series of prompts requesting entries.
A detailed procedure (with displays of prompts) is provided in later
sections of this manual.
01
Ç
Zone Number
Interactive Mode
✱ 56 Zone Programming
✱ 58 Expert Mode
✱ 80 Relay Programming
✱ 81 Zone List
✱ 82 Alpha Programming
✱ ✱
] + Field No. + [ ] (applies only to fields
✱ 80, ✱ 81, and ✱ 82)
✱
] + Interactive Mode No. (for example,
Programming
Programming
✱
97, then exit the Programming mode.
Enter 1 if 5881 RF Receiver without RF Jam Detection is being used;
enter 4 if 5881/5882 RF Receiver with Jam Detection is being used; if
no RF receiver is being used, enter 0 (the default value).
Use this field to select the type of expansion unit being used.
✱ ✱
40- 44,
✱
56). The alpha
Used to Program
Zone characteristics, report codes, alpha
descriptors, and serial numbers
Zone characteristics, report codes, and
serial numbers.
4204 or 4229 Relay modules, or
Powerline Carrier devices
Zone lists for relay/powerline carrier,
cross zone activation, and NIGHT-STAY
Zones
Zone alpha descriptors
EXPLANATION
✱
] and the next
✱ ✱
88, and 94).