ADEMCO
Vista-15 Installation And Setup Manual page 69

NIGHT-STAY
MAXIMUM
† The VISTA-15/VISTA-15CN contains an Exit Delay Reset feature that allows the user to exit (fault), close the
door (restore the fault), then re-enter (fault again) the premises within the exit delay time period. Upon re-
entering, a new exit delay time period is begun with the keypad annunciating three rapid beeps. This feature
only resets the exit delay one time for each arming session.
PANIC Keys
There are three PANIC key pairs, OR (on keypads 6128 and 6139 keypads if Quick Arm is disabled in field
lettered keys that can be used to manually initiate alarms and send a report to the Central Station. Lettered keys can
only initiate the alarms if Quick Arm (field
Each can be individually programmed for 24-hour Silent, Audible, Personal, or Fire Emergency responses. The Panic
function is activated when both keys of the appropriate key pair are pressed at the same time, or the appropriate
lettered key is pressed for at least 2 seconds.
The Panic functions are identified by the system as follows:
Important: For the Silent Panic functions to be of practical value, the system must be connected to a Central Station.
Relay/Powerline Carrier Device Activation
If relay outputs (via a 4204 or 4229) or Powerline Carrier devices are used, two keypad entries available to the user are
included. They can manually activate or deactivate the device(s) for starting or stopping some action, such as turning
lights on or off, etc.
These keypad entries are:
[Security Code] + [#] + [7] + Device No. activates (starts) that device.
[Security Code] + [#] + [8] + Device No. deactivates (stops) that device.
4285/4286 VIP Module (if used)
Refer to the separate instructions supplied with the VIP module for information concerning its operating procedures.
The VIP (phone module) cannot be used to add user codes in this system. User codes must be added by
using a wired keypad.
Arming
Mode
Exit Delay
Yes
STAY
Yes
INSTANT Yes
Yes
AWAY
Yes
✱
21) is disabled.
Keys Displayed as Zone
✱
1 + , or A
✱
+ #, or B
3 + #, or C
Pager Msg is Sent
D
SUMMARY OF ARMING MODES
Features for Each Arming Mode
†
Entry Delay
Yes
Yes
No
Yes
No
Notes:
• Keys A, B, and C are not on all keypads
95
as indicated.
• Key D, if present, with pager enabled in
99
field ✱ 47, sends a 999-9999 message to
96
the pager. The message signifies ANY
message the user and recipient have
decided is appropriate, and is
independent of the Quick Arm field.
Section 12: System Operation
Perimeter Armed Interior Armed
Yes
Yes Yes (if in Zone List 05)
Yes
Yes
Yes
No
No
Yes
Yes
✱
21),
12–3