ADEMCO
Vista-15 Installation And Setup Manual page 44

VISTA-15/VISTA-15CN Installation and Setup Guide
10 Report Code
1st 01 2nd 00
02 Response Time
10 INPUT TYPE
RF TRANS
10 INPUT S/N:
A 0 2 2 - 4 0 6 4
Note: The [A] and [B] keys
may be used to move the
cursor to the right (A) or left
(B) within the serial number
field, thus allowing you to
correct any entry errors that
may have been made.
10 INPUT S/N
A 0 2 2 - 4 0 6 4
6–2
Default values for hardwired zones 1 to 6 are:
Zone No. (Zn):
Zone Type Default:
Response Time Default ††
† Fire verification is applicable on zone 1 only.
†† 1 for response time = 350mSec.
✱
Press [ ] to continue.
Report Code (RC): Enter the report code. This consists of 2 hexadecimal
digits, each in turn consisting of 2 numerical digits. For example, for a
10
report code of "10," enter 01 and 00. Refer to Section 21: System
Communication for more information about report codes and report code
formats.
✱
Press [ ] to continue.
Note that report codes are defaulted to 10 for use with CID reporting.
Response Time (RT): Enter the desired response time for hard-wired
zones 01-06 (zone 02 is used as an example in display at left). 0 = 10mSec,
1
1 = 350mSec, or 2 = 700mSec.
Default value = 1 for all zones.
✱
Press [ ] to continue.
Enter Input Device type (In). Used for Input Type entry.
2 = AW (Aux wired zone)
3
3 = RF (supervised RF transmitter)
4 = UR (unsupervised RF transmitter)
5 = Button type RF transmitter (unsupervised)
NOTE: For the built-in hardwired zones, the Input Device type is auto-
matically displayed as HW and cannot be edited.
✱
Press [ ] to continue.
Serial number Entry and Loop Number Entry.
L
Used only when enrolling wireless transmitters.
1
a.
Transmit two open and close sequences. If using a button-type
transmitter, press and release the button twice
OR
b.
Manually enter the 7-digit serial number printed on the label of the
transmitter, using the alpha display keypad.
OR
c.
To copy the serial number previously enrolled (used when programming
a transmitter with several input loops), simply press key [C].
The cursor then moves to the "L." You can edit the loop number, if
necessary. When the loop number is acceptable, press [
NOTE: If you use the [C] key to copy the previously enrolled serial
L
number, the cursor moves to the Loop column (L) with the previous serial
?
number displayed, and displays a question '?" mark for the loop number.
Enter the loop number and press [
The system then checks for a duplicate serial/loop number combination.
If a duplicate serial/loop number combination is found, the keypad emits
a single long beep, and prompts with a "?" again for a different loop
entry.
1 2 3 4
09 01 01 03
1 1 1 1
✱
].
✱
].
5 6
03 03
1 1